16
© 2018
– HRMTEC – www.hrmtec.com
v1.6e
Ribbon width
Left Margin
Right Margin
75 mm
88 mm
88 mm
100 mm
76 mm
76 mm
125 mm
63 mm
63 mm
150 mm
51 mm
51 mm
175 mm
38 mm
38 mm
200 mm
26 mm
26 mm
225 mm
13 mm
13 mm
Table 1
MARGIN
ADJUSTMENTS
PER
WIDTH
Using the settings shown in the table has the advantage that you can see in the print
preview what the entered text looks like on the ribbon. The printing range should be
considered as the ribbon. You can also see here if the entered text does not fit on the
ribbon.
NOTE:
When using other widths or ribbons with borders, the margin setting (left or right)
is calculated as follows:
Margin [mm] = (252 [mm]
– Ribbon Width [mm]) / 2
3.3
Embossing Process
3.3.1
Preparations
The 123 Schleifenprofi VX embossing machine is switched on, ribbon and printing foil
are inserted according to the description. Your ribbon printing software is started and
you have a layout ready (usually the left ribbon with a commemorative note and the
right ribbon with the names of the survivors).
3.3.2
Embossing
In the ribbon print program execute the function "Print".
The 123 Schleifenprofi VX embossing machine prints the left ribbon. After embossing
the left ribbon, you can print the right ribbon with the same steps.
3.3.2.1
Printing Foil Consumption
To optimize the print film consumption, you have reduced the layout to the minimum
size of the text field. This means that you have to
manually
pull the ribbon a little bit
(for example 30 cm) out of the embossing machine ("feed"), then emboss the text, and
then
manually
pull the ribbon out of the embossing machine to reach the desired
ribbon length. You can also use the key 5 "Fwd" (ribbon forward, see
Error! Reference