19
© 2018
– HRMTEC – www.hrmtec.com
v1.6e
4. Maintenance
The print head is a precise and sensitive electronic device. It can be damaged by
hard
/ pointed objects
,
electrostatic discharge
or
liquids
.
To reduce the risk of damage and increase the service life, please handle the print
head
with care
.
The surface of the print head consists of a thin layer of silicon dioxide protective film,
but can also be damaged by hard / pointed objects, electrostatic discharge or liquids.
The operation should be as described below:
1. Do not touch the hot area of the print head directly.
2. Make sure the print media (ribbon) is clean, with no hard particles (such as stapler
clips or paper clips) or droplets on the surface.
3. Do not touch the surface of the print head with metallic or hard objects.
4. Keep the workplace clean and tidy. Protect the embossing machine from dust and
moisture.
4.1
Clean Print head
After printing about 100 ribbons, please clean the print head as follows:
1. Remove the printing foil.
2. Lift the print head by pressing the 4 button (see
Error! Reference source not
found.
)
3. Disconnect the power and unplug the power cable.
4. Use a cotton swab (
dry
) to gently clean the print head
5. After cleaning the surface, check that there are no more foil residues on the print
head.
6. Reload the printing foil, reconnect the power and turn the power back on, and the
123 Schleifenprofi VX embossing machine is ready for additional embossing.
4.2
Storage of Printing Foils
The printing foils, as well as the ribbon, must be stored with care.
Store the printing foils and ribbon in a place where the room temperature is in the range
of 5-30
o
C and the humidity is in the range of 20%-80%. It is prohibited to store the
printing foils in direct sunlight or in a damp place.
The printing foils and the ribbon should be stored
standing on their front side
.
