−
8
−
4-2. Preparing an electric cable
(1) Processing the terminal
1) Be sure to strip the covering at the top of the electric cable in prior. (Refer to the stripping length given in “5.
Crimping quality. P.12”)
2) When stripping the covering, carefully avoid the cable core from breaking, being nicked, loosening and bending.
4-3. Making preparation for crimping operation
CAUTION :
To protect against possible accidents due to abrupt start of the machine, start your work after
disconnecting the power to the main unit of the crimping machine.
(1) How to conduct crimping operation
1) Set wire disk
1
, spacer disk
2
and insulation crimp height adjusting dial
3
as illustrated to the positions same
as shown in the sketch on the left (A-W-1).
2) Connect the power plug of the main unit of the crimping machine to the power receptacle and turn on the main
power switch.
3) Lightly press the stripped end of the electric cable against wire stopper
4
at a position that is almost just above
the terminal.
(Caution) When crimping is performed in the state that the electric cable is apart from wire stopper
4
or
strongly pressed to wire stopper
4
defective quality of crimping will be caused.
4) Depress the foot switch.
Then, crimping performance is carried out by the up-and-down movement of the applicator ram every time the
ram unit of the crimping machine makes an up-and-down movement.
4-2. 电线的准备
(1) 终端加工
1) 请首先剥去电线的前端被覆。( 参照 5.「压接质量」(P.12)，剥皮长度 )
2) 剥皮时，请注意不要弄伤和切断芯线，也不要参差不齐和弯曲。
4-3. 压接作业准备
(1) 压接作业方法
1) 请把线圆盘
1
、衬垫圆盘
2
、绝缘夹紧高度调整拨盘
3
安装到左图所示的位置 (A-W-1)。
2) 请把压接机主机的电源插头插到电源插座上，然后打开 (ON) 主电源开关。
3) 把剥皮后的电线前端轻轻地顶到线止动器
4
。
( 注意 ) 请不要让电缆离开线止动器
4
也不要向线止动器
4
顶得过强，否则会发生压接质量不良。
4) 请踩脚踏开关。
踩踏板之后，压接机凸轮部上下动作 1 次，供料器凸轮开始上下动作进行压接。
为了防止突然的起动造成事故，请关掉压接机主机的电源之后再进行操作。
注意
Summary of Contents for AP105
Page 42: ... 29 MEMO ...
