−
14
−
6. Maintenance
Caution :
1. To prevent possible accidents caused by unfamiliarity with the operation of the machine, repair
and adjustment of the machine shall be conducted only by maintenance personnel who has a
full knowledge of the machine. Any repair and adjustment beyond the range covered by the
instructions given in this Instruction is prohibited. We assume no responsibility for accidents
caused by improper repair or adjustment or the use of non-genuine part(s).
2. To conduct maintenance works, be sure to detach the applicator from the crimping machine prior.
(1) Lubrication
(1)-1. Sliding section of the ram
1) Periodically once a week, apply a light coating of grease to side face
1
, rear face
2
and cam follower section
3
of the frame.
Designated grease = NLGI No. 2 grease for centralized lubrication
(Caution) Avoid excessive oiling.
(1)-2. Sliding section of the terminal feed mechanism
1) Periodically once a week, apply a few drops of oil to feed rod
4
and adjust rod
5
.
Designated oil = ISO VG32
(Caution) Avoid excessive oiling.
(2) Routine maintenance and inspection
1) Check to be sure that no carrier chips and dust gather in each sliding section.
The residue of plating is apt to adhere to the section
6
. Periodically (at the end of the daily work, at the time of
replacement of the reel, etc.) wipe there with waste soaked with alcohol. Or the like.
2) It is recommended to store the machine, when not in use, in a clean and dry place to avoid dust and dirt.
3) To put the machine into service, be sure to check in prior that proper expendable parts are installed on the
machine.
6. 维修
(1) 加油
(1)-1 压头活动部
1) 请每星期向压头侧面
1
、背面
2
、机架的凸轮部
3
薄薄地涂 1 次润滑脂。
指定润滑脂＝集中加油用润滑脂 NL GI 2 号
( 注意 ) 请不要过度加油。
(1)-2 端子传送机构活动部
1) 请每星期向供料杆
4
、调节杆
5
滴 1 次 2 〜 3 滴的机油。
指定机油＝ ISO VG32
( 注意 ) 请不要过度加油。
(2) 关于日常保养
1) 请确认各滑动部上是否没有传送芯片和脏污等。
6
部容易粘附电镀渣，所以请定期地 ( 每日工作结束或更换卷盘后 ) 涂抹乙醇或用棉纱擦拭。
2) 不使用时，请放到没有灰尘和潮湿的地方保管。
3) 使用时，请一定确认消耗零件是正规零件后再使用。
注意
1. 为了防止因不熟练发生事故，一定请熟悉机器的维修技术人员在本使用说明书规定范围内
修理、调整机器。另外，更换零件时，请一定使用本公司的纯正零件。对于错误的修理和
调整以及非纯正零件发生的事故，本公司不负任何责任。
2. 进行操作时，请一定从压接机卸下供料器之后再进行操作。
Summary of Contents for AP105
Page 42: ... 29 MEMO ...
