HRS DF19G Series, Instruction Manual

- 9 -

 IV. Repairing procedure in case of failure of connection

1)  Turn over the connector main body which has been failed in connection.
2)  Insert pulling tool 

④

 between connector main body 

①

 and lock section (4 places) 

③

 of ground plate 

②

 and  

remove the click. 

  Pulling tool : DF-C-PO (B) (Optional)
3)  Press down the ground plate to open it.
4)  Press FPC 

⑤

 and ground plate 

②

 by fingers and pull out connector main body 

①

.

5)  Remove ground plate 

②

 from the FPC

⑤

.

Ground plate 

②

FPC

⑤

Connector 

main body 

①

Pulling tool : DF-C-PO (B)

           Optional 

④

FPC

⑤

Ground plate

②

Pull out

Lock section

③

 (4 places right/left)  

1.  Do not perform re-connection of the connector main body and ground plate for which repair has    

been performed. Scrap them.

 2.  Do not perform more than one time re-connection to FPC for which repair has been performed.
 3.  Handle the pulling tool with care since the tip of it is very sharp. 

Connector 

main body 

①

Jan.1.2020 Copyright 2020 HIROSE ELECTRIC CO., LTD. All Rights Reserved.