RevE 18/02/14
18
Attaching the Remote Control Receiver Box
The control lead is then attached to the receiver box using the plastic
connector and to the valve motor by the two spade terminals.
The Remote Control Receiver Box is powered by 4 x AA batteries
(supplied). The batteries are fitted by sliding the cover off the receiver
box the orientation of the batteries shown on the diagram in the box.
Fit the 9-volt battery to the remote control handset.
Test that the remote control system is working by pressing the increase
and decrease buttons on the handset.
If the system is working correctly, the receiver box can be sited. The
ideal position for the receiver box being on the hearth, at the back of
the stove. The remote control system is ultra-sonic and hence the
receiver box does not have to be in line of sight of the remote handset.
WARNING!
The receiver box should not be sited anywhere that the temperature
will be greater than 50
Celsius. High temperatures will shorten the
battery life and may cause the remote control receiver to stop
operating.
SERVICING INSTRUCTIONS
It must be understood that any recommendations made here are in
addition to the standard servicing procedures used by the servicing
engineer.
1.
A GAS SAFE registered fitter using only original HS GAS parts
should carry out servicing.
2.
Remove the stove body and glass as described on Page 6
(Removing the Stove Body).
3.
Carefully lift-off the ceramic coals/logs and remove the 3
ceramic matrices.
4.
Using a soft brush, clean away any lint or light carbon soot
deposits out of the gas ports on the burner top plate.
5.
Check the TTB bracket inside the draught diverter for blockage
and clean as necessary.
6.
Replace the ceramic matrices and loose coals/logs as per the
arrangement instructions (Page 9- Fire-bed Arrangement) using
all re-serviceable coals/logs and any new replacements.
Replace the glass, stove body and the doors.
7.
Check the gas operating pressure and pipe work for soundness,
carry out a spillage test and check the condition of the flue
system.