HSD
5801H0056
______________________________________________________________
153/181
13.
Reassemble the phonic wheel.
Warning:
Align the tang of the “Z” zero with the notch on
the shaft.
After fixing the phonic wheel, check that the
dynamic balancing level at maximum speed is
G=2.5 or better.
If this is not the case, contact HSD.
14.
To assemble the encoder reader at the right
distance, insert a 0.2mm thickness spacer
between the reader itself and the phonic wheel.
Block with two 4x10 screws and Z5 knurled
washers, then remove the thickness spacer.
15.
Before reassembling the cylinder, check (on the
machine) the encoder is working.
16.
Replace the layer of Loctite 510 (or equivalent)
on the cylinder area.
17.
Reassemble the cylinder and follow steps 7-1
(i.e. in reverse order) to completely reassemble
the spindle.
18.
Carry out the sensor calibration procedure.
Z
