IX
、
CLEANING & MAINTENANCE
A
、
CLEANING & MAINTENANCE
The parts shown below should be cleaned each day, the housing each week. Please
use a brush & cleaning oil to remove heavy build up. If oil is used, be sure to wipe
parts dry to minimize new residue build-up.
(1). piston
(2). inside and outside of fastener guide
(3). inside of liner
(4). inside and outside of barrel
B
、
REASSEMBLY
1.
Insert piston in the barrel.
2.
Insert fastener guide in the barrel.
3.
Insert the barrel in liner (Slot in the barrel must align with silencer)
X
、
TROUBLE SHOOTING
A
、
MISFIRE PROCEDURE
If the tool does not fire after squeezing trigger, continue to hold the depressed
tool firmly against the work surface for at least
30
seconds. This will protect the
operator and bystanders from injury in the event of a delayed firing. Then,
carefully open the tool, remove the load strip, and put it into a container of water
or other nonflammable liquid. Never carelessly discard, or throw into a trash
container, any unfired strip load.
B
、
THE BUFFER IS DAMAGED BY OVERDRIVNG A FASTENER
If the damaged buffer jams on the piston, you may strike protruding piston
sharply against a hard surface. This will separate piston and buffer. Remove
piston completely from fastener guide. Pull buffer off fastener guide to one
side and press in a new one.
