16
HSM SECURIO P36i
02/2017
english
• In the case of particle cut machines,
fi
ll the oil
reservoir with cutting head oil (see Section 7
“Filling the oil reservoir”).
• Connect the power plug of the machine into a
properly installed socket.
• Before starting up the machine for the
fi
rst
time, open the door and remove the three
wing nuts of the transport locks from the base
plate under the cutting unit.
6 Operation
The shredder has 3 operating modes which vary with regard to shredding speed, throughput and
noise emission level:
Silent:
for especially quiet operation
Standard:
for optimum throughput capacity with low noise levels
Performance:
for maximum shredding and throughput capacity
The machine is ready to operate.
Note
Paper and CD cutting unit cannot be used at the same time. Only shred one kind of material at a
time.
• Set mains switch at rear of paper shredder to „I“.
• The
fi
rst time you switch on, select the language for the display messages.
The set operating mode is displayed.
Swipe to change the operating mode.
Note
The temperature of the shredder motor is monitored. Should it overheat, not all operating modes
can be selected. You are informed of the situation by a message on the display. Once the motor has
cooled down suf
fi
ciently, all modes are available again.
Switching on the shredder
Summary of Contents for 1852121
Page 223: ...02 2017 HSM SECURIO P36i 223 ...
