HSM FA 490.1, Operating Instructions Manual

8

0912

FA 490.1

7  Start-up and inspecting the safety 

devices

Check that the safety devices are working 
properly:

• At the start of each shift
• After any maintenance or repair work

Do not start the machine until you have 
checked the safety devices and found them 
to be in perfect working order. If any defect 
arises during operation stop the machine im-
mediately and make sure it is corrected.

Switching on the paper shredder

•  Unlock the emergency stop button by turn-

ing it anticlockwise.

•  Solo-version: Turn the main switch to the 

I

position.
Combination-version: Turn the main switch 
on the baling press to the 

I

 position.

`

 The green „Ready for operation“ LED 

lights up.

•  Press the green start button.

`

 The cutting block and feed belt start up.

Caution! 

The feed belt can run in reverse if the phase 
wires in the power plug are incorrectly con-
nected.
Turn off the main switch immediately and 
pull out the power plug!  Have an electrician 
change two of the three phase wires.

Checking the emergency stop button

Press the emergency stop button 
while the machine is running. 
The shredder must switch off immedi-
ately. The cutting block and the feed 
belt must stop.
The machine will only start again once 
you have pulled out the emergency 
stop button again

Safety 

fl

 ap on the feed belt

Open the safety 

fl

 ap. 

The shredder must switch off immediately and the 

”

Safety 

circuit interrupted

”

 LED must light up.

The machine will only start again once you have closed 
the safety 

fl

 ap.

Safety switch on the dust tray

Pull out the dust tray.
The shredder must switch off immediately and the 

”

Safety 

circuit interrupted

”

 LED must light up.

The machine will only start again once you have pushed 
in the dust tray completely.