1002
9
FA 500.2
Safety switch on the inspection door (only
stand alone-version)
Open the inspection door.
The shredder must switch off immediately and the
”
Safety
circuit interrupted
”
LED must light up.
The machine will only start again once you have closed
the inspection door.
Safety switch on the protective fl ap (only
stand alone-version)
Open the protective fl ap.
The shredder must switch off immediately and the
”
Safety
circuit interrupted
”
LED must light up.
The machine will only start again once the protective fl ap
is in its basic (vertical) position.
• Press the green start button.
`
The cutting block and feed belt start up.
• Place the material to be shredded on the
loading tray and then place batches on the
feed belt.
If material that is not supposed to be shred-
ded is mistakenly placed onto the belt, never
attempt to pull it out
• Press the stop button.
`
The drive stops.
• Press the reverse button.
`
The cutting block and feed belt run in
reverse.
• You can now remove the material from the
belt and start the shredder again by press-
ing the start button.
Stopping the shredder
• Press the stop button.
`
The cutting block and feed belt stop.
`
The shredder switches to standby mode.
Switching off the shredder
• Turn the main switch on the paper shred-
der or the baling press to 0.
You can secure the main switch in this
position using a padlock.
Shredding material
http://www.monomachines.com/
http://www.monomachines.com/
Summary of Contents for HSM FA 500.2
