02/2017
HSM SECURIO P44i
19
english
Message
displayed
Fault cause
Remedy
Door open
Door open
• Close the door.
Safety element
active
Safety ele-
ment not
engaged
• Snap the safety element into place.
Note
The movement of the safety element is monitored during the shred-
ding process.
Metal detection
Metal in the
paper
• Press the “R” button and pull the paper out of the feed slot.
• Remove any metal which is in the paper or on the safety element.
• Acknowledge the fault.
Motor overloaded
The motor has
overheated.
• Allow the shredder to cool down for 30 min. before using it again.
Light barrier dusty
Photoelectric
beam ob-
scured by
paper dust
• Clean the photoelectric sensor in the paper feed using a dry brush
or cloth.
Oil reservoir empty Oil reservoir
empty
• Fill the reservoir with cutting apparatus oil.
Only use HSM special oil.
Reservoir volume: 250 ml
Press the safety element and lift up the
fl
ap. The
oil
fi
lling opening is to the right of the feed chute.
You can
fi
ll the oil either through the small open-
ing
1
(take out the yellow plug) or the normal
opening
2
(unscrew the red cap).
1
2
Summary of Contents for SECURIO P44i
Page 223: ...02 2017 HSM SECURIO P44i 223 ...
