02/2011
9
english
LED
-
indicator
Cause
Remedy
No LED lights up
-
Place the cutting head correctly on the base cabinet
and push the containers for shredded paper and CDs in
properly.
Press “
I
” on the switch
.
Both LEDs light up
The shredded
paper container
is full
Empty the container.
If you take the cutting head off the base cabinet, take
care not to damage the
fl
ap on the bottom of the cutting
head.
The red LED
fl
ashes Overheating
The maximum uninterrupted operating time is
fi
ve
minutes. Let the machine cool down for around
20 minutes.
Only the red LED
lights up
Paper cutting
unit overloaded
Press “
R
” on the switch.
Note:
The cutting unit starts up with a delay of two
seconds.
Remove the paper.
Do not feed in more than 8 sheets of paper at a time.
For any other malfunctions, switch off the machine and get in touch with our customer service.
6 Troubleshooting
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
may enter the equipment.
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container.
• Squirt special cutting unit oil (order number
1.235.997.403) through the paper feed
across the entire width of the cutting shafts.
• Without feeding in paper, run the cutting unit
in reverse (
R
).
This loosens paper dust and particles.
7 Cleaning and maintenance
Push down the front of the container (1), push it
back (2) and lift the container out of the bracket
(3).
Note that the shredder can only be switched on
when the CD container is properly in place.
1
2
3
Instructions on removing the CD container
Summary of Contents for Shred Star X8pro
Page 71: ...02 2011 71 ...
