11/2012
SP 4040
7
SP 4040
– Do not carry out any tasks which may endanger your safety while operating the ma-
chine.
– Any changes which take place and could impair safety should be reported immediately.
Put the machine out of operation until the damage is rectifi ed.
– Always make sure the machine is in perfect condition before you switch it on.
– Make sure the area around the shredder-press combination is clean and safe.
– Unauthorised modifi cations and changes to the machine are strictly prohibited. Protec-
tive devices may not be removed or otherwise rendered inoperative.
– No work on the machine which is not part of its normal operation may be performed
while the machine is still running.
– Never open doors and fl aps before the machine has been shut down. Note the instruc-
tion plate.
– Test the protective measures installed after any electrical or repair work.
– No platforms or other raised surfaces may be placed near the shredder-press combina-
tion if they encroach on the specifi ed safety clearances.
– Connecting cables must be laid in such a way that they cannot be tripped over.
– Only persons with the appropriate skills and experience in hydraulics may carry out
work on the hydraulic equipment.
– All lines, pipes and bolted joints must be regularly inspected for looseness, leaks and
visible damage. Any damage must be repaired immediately. Escaping oil can cause
fi re and injury!
– Any parts of the system and hydraulic pressure lines that need to be opened must be
depressurised according to the assembly instructions before commencing repair work.
