XI
When the printer connected to the power adapter, ppress (feed)
key and open the printer power at the same time, released the button
after approximately 10 seconds, printer is restored to factory settings.
Cutter stuck maintenance
Solution 1:Press the power switch to turn off the printer power,
restart, let the cutter back.
Solution 2:Open the printer cover, rotating the printing head cutting
knife gear, let the cutter return to its initial position, open the cover and
install paper roll then can can print normally.
Note: do not force open the cover, as to avoid unrecoverable
damage to the print head and the cutter.
Printer driver
80MM series thermal printer driver mode has two kinds, one is
using the port for directly drive printing, one is in stall driver in Windows
system to print.
1.port direct drive