HSR-BENELLI SERIES-S Manual | EN -
2
1.9 Characteristics of the jet drive
The drive works through the intakes on the bottom sides of the boat via the intake grid. In this area there is the
jet pump which ejects the water backwards via an impeller.
1.10 Breaking-in of the Series-S according to your possibilities
Observe the following regulations and recommendations and you will have lots of fun with your HSR-BENELLI
Series-S:
During the first 5 minutes of riding time, do not exceed the average speed of 2500 rpm.
Do not run the engine during the first 5 hours with more than 3/4 acceleration on the lever, and do not
overstrain it.
Accelerate only for very short times and then ride again with average rpm. Warm up: With the Series-S
natural aspirated engine, you must warm up the engine after each start.
•
•
•
Summary of Contents for S-series
