21
Tools - access of tools
The grinder must be tilted backwards in order to mount and
change tools.
Raise the handle to upright position and set the weights
furthest back, see picture 1.
To get a better effect when tilting the grinder, the operator
can put one foot against the frame and slowly tilt the grind
-
er until the back weights reach the floor, see picture 2.
Always disconnect mains voltage from the grinder when
working with the grinding tools. Also remember that the
tools can be extremely hot following grinding work.
Picture.1..Fold.the.handle.straight.up.and.then.set.the.weights.
to.back.position..Put.one.foot.against.the.frame.and.pull.the.ma-
chine.towards.you.
Picture.2..Tilt.the.grinder.backwards.until.the.weights.reach.the.
floor.
Picture.3..Tilt.the.grinder.backwards.some.more.until.the.weight.
lock touches the floor.
Picture.4..Grip.the.handle.again.with.one.hand.and.lift.the.grinder.
high.enough.so.that.you.can.lock.the.weight.in.its.vertical.posi-
tion..Loosen.the.pins.before.the.grinder.reverts.to.its.normal.posi-
tion.following.tool.change.
Summary of Contents for 950 RX
