Safety
The grinder may only be operated or repaired by personnel who have undergone practical or theoretical training and have read through
this manual.
The instructions in this manual must be observed in order for CE marking to apply.
Only use the machine for grinding or polishing unhewn stone, terrazzo, concrete or any other material specified in this manual.
Do not use the machine in environments where there is a risk of explosion or fire.
Wear personal protective equipment at all times - safety boots, ear muffs, protective goggles and protective gloves.
Do not start the machine in folded position. Only start the grinder with the rotating discs facing the floor and with the tools applied.
Be careful when replacing grinding tools as the tools and metal discs can be hot.
Disconnect the power supply from the machine when replacing the grinding tools.
Only lift the machine using the parts specified in this manual.
Do not use the machine on sloping surfaces.
Do not move the machine manually on sloping surfaces as there is a major risk of crushing if the machine starts to roll.
Always tilt the machine after grinding when removing glue or when wet grinding so that the machine does not get stuck to the floor and
destroy machine parts or the floor when restarting.
Always keep the machine in a dry and warm area when it is not being used.
If the machine is kept in a cold area, it must stand in a heated room for two hours prior to use.
Only use the machine with the splash guard fitted.
Only use HTC original tools and original spare parts.
Summary of Contents for 950 RX
