General Safety Instructions for Power Tools
Using power tools of any kind can be dangerous if safe operating
procedures are not followed. Recognizing the hazards of each tool and
using them with respect and caution will considerably limit the possibility of
personal injury. However, if safety precautions are ignored, personal injury
will likely result. Always use common sense – your personal safety-is your
responsibility. Know your power tool. Read and understand the Operator’s
Manual and observe the warnings and instruction labels affixed to the tool.
Safety Instructions for Saw Horses
1. Use caution when folding or unfolding legs to limit any finger pinch points.
2. Place stand on flat and level surface to keep tool from rocking or tipping.
3.
Do not exceed 500 lbs. per stand.
4. Test the setup for stability before proceeding with work.
Assembly Instructions
Read all assembly instructions completely before attempting assembly.
See parts list on Page 2 for names and pictures of parts. Identify all
components and hardware.
1. Install
Leg
as shown in
Figure 1 to Top Frame
and secure with 1/4" - 20 x
1-3/4" Bolt
and 1/4" Lock
Nut
. Insure that Snap Pin
is facing out and securly
latches in the open and
closed positions. Do not over
tighten. Repeat on remaining
three Legs.
2. Place top frame upside down
on your workbench or work
surface. Open the legs by
depressing the snap pins
and pivot the legs into the
open position. Figure 2.
3. Install 1-1/4" Tube Plugs
into the bottom of all
four legs, as shown in Figure
3. Return unit to upright
position.
Figure 2
Figure 3:
Legs Represented in Open Position
2
Figure 1
3
Congratulations
You have just purchased a PM3300 Folding Saw Horse.
Parts
Description
Part No. Qty
Top
Frame
5107
1
Leg
2974
4
Snap
Pin
F103
4
1/4" - 20 x 1-3/4" Hex Head Bolt D140
4
1/4" - 20 Lock Nut
D102
4
1/4" - 20 Serrated Flange Nut
D118
8
5/16" - 18 3-Point Knob
G101
4
Leg
Plugs
(right)
2908R 2
Leg
Plugs
(left)
2908L 2