lp-666 Rev. 003 Rel. 001 Date 2.25.20
9
WARNING
!
Use extreme care not to drop the boiler or cause bodily injury
while lifting the boiler. Failure to follow these instructions could
result in property damage, severe personal injury, or death.
WARNING
!
400 - 1000 Models ONLY are approved for installation on
combustible flooring, but must never be installed on carpeting.
1500 - 2000 MODELS ARE NOT APPROVED FOR INSTALLATION
ON COMBUSTIBLE FLOORING. Failure to follow these instructions
could result in fire, property damage, severe personal injury, or
death.
B. Flooring
C. Leveling
CAUTION
!
In order for the condensate to properly flow out of the collection
system, the area where you locate the boiler must be level.
Location must also fully support the weight of the filled boiler. See
Figures 2 - 4.
Ensure that the floor and structure of the installation location
are sufficient to support the full installed weight of the boiler,
including water content of the heat exchanger and related piping.
Failure to ensure the floor and structure of the installation location
are structurally sound before installation of the boiler can result
in structural failure, substantial property damage, severe personal
injury, or death.
LP-666-R
01/03/19
INCORRECT
CORRECT
Figure 3 - Caster Wheel Adjustment - 400 - 1000 Models ONLY
Figure 2 - Leveling - 400 - 1000 Models
LOWER
TURN WHEEL TO THE
RIGHT TO LOWER
RUBBER FOOT
TURN WHEEL
TO THE LEFT TO RAISE
RUBBER FOOT
RAISE
01/24/19
LP-517-W
Figure 4 - Leveling - 1500 - 2000 Models
CORRECT
INCORRECT
1
2
Figure 5 - 1500 - 2000 Models - Installing Decorative Skirts
1500 - 2000 Models ONLY
- After the boiler has been installed level
in the final location the decorative skirts may be installed. These can
be found in the boiler cabinet. Use the included bolts to install the
front skirt (1) before proceeding to the side skirts (2). See Figure 5.
