39
40
LP-532 REV. 8.13.2014
LP-532 REV. 8.13.2014
Water flow rate (GPM or LPM)
Program Lock mode
Fan Speed (RPM)
Operating Temperature from the Heat Exchanger
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
HIGH
C
F
Press power button to turn on the
unit.
Press ‘current status’ for 5
secs and ‘A:GA’ will show up.
Default setting in common.
Water flow status will be displayed.
(ex : 2.64)
Press ‘dial button’ for a sec again, to
go back to the previous mode.
After ‘A:GA’ has been displayed by
pressing ‘current status button’ for 5
secs, turn the dial until it shows ‘b:Fr‘.
After ‘A:GA’ has been displayed by
pressing ‘current status button’ for 5
secs, turn the dial until it shows ‘d:Lc‘.
Check RPM by pressing ‘dial button’
for 1 sec when ‘b:Fr’ shows up
Press the dial button for 1 sec when
‘d:Lc‘ shows up.
Press ‘dial button’ for a sec again, to
go back to ‘b:Fr’ mode.
Press ‘dial button’ for a sec again, to
go back to ‘d:Lc‘ mode.
Press ‘current status’ button with
‘b:Fr’ mode to go back to the initial
status.
Press ‘current status’ button with
‘d:Lc‘ mode to go back to the initial
status.
Fan RPM’s current status will be
displayed.(ex : 3000rpm)
Turn the dial until current status ‘off’
mode turns into ‘on’.
After ‘A:GA’ has been displayed
by pressing ‘current status button’
for 5 secs, turn the dial until it
shows ‘E:oP’.
Press ‘dial button’ for 1 sec when
‘E:oP’ shows up
Press ‘dial button’ for a sec again, to
go back to the previous mode.
Press ‘current status button’ during
‘E:oP’ mode to go back to the initial
status.
Current return water temperature
status will be displayed. (ex : 108℉)
Chapter 3 How to use control panel
Chapter 3 How to use control panel
HIGH
C
F
View System Parameters
HIGH
C
F
