|
53
Temperature Switch TS 2-1000
52
| Error messages
15 errOr messages
The device can show the following messages:
error n1
Err1
error n2
Err2
error n3
Err3
note:
if an error occurs all relays are set to OFF.
16 maInTenance
The device is basically maintenance free. All sensors should be checked at
regular intervals for dirt or corrosion and consequently be cleaned. The full
function of the device can be guaranteed, if the device and the sensors are
serviced and activated at regular intervals.
cleanIng
Clean the device the soft lint free cloth. The cloth may be dampened slightly if
the device is very dirty. To clean the device, make sure that it is disconnected
from the mains
malFuncTIOn
Only use the device if it is functioning without disturbance. If there is any
malfunction, switch off the device immediately and consults a specialist. The
device may only be reinstalled after it has been checked thoroughly. Signs of
malfunction are if:
– The device is visibly damaged.
– The device is malfunctioning.
– Attached cables or the housing has come loose.
Repairs may only be done by a qualified person or a specialist using original
components and parts. There is the danger of electrocution.
enVIrOnmenTal nOTes
Consumers are legally obligated and responsible for the proper
disposal of electronic and electrical devices by returning them to
collecting sites designated for the recycling of electrical and electronic
equipment waste. This device and/or components within the device
can be recycled. For more information concerning disposal sites, please contact
your local authority or waste management company.
17 WarranTy
The dealer/manufacturer from which you have purchased this device gives a
guarantee for material and function of the device for two years. Should functional
defect occur, then the dealer/manufacturer has the right to repair or exchange
the device. All exchanged devices are property of the dealer/manufacturer. The
customer is committed to indicating any defects immediately together with the
purchasing invoice.
The dealer/manufacturer cannot be made liable for defects or malfunctions that
occur due to incorrect handling, incorrect mounting, incorrect assembly, the use
of non-authorized components or unauthorized changes applied to the device.
He can also not be made liable if the instruction manual has not been read and
followed. In this case also all rights for guarantee will be void.
The dealer/manufacturer cannot be made liable for any costs and risks occurring
through transport, mounting, assembly or any consequential repairs and/or costs.
Err 1 shows that a short-circuit has been detected in the
thermometer sensor or that the measured value is below
-99°C.
Err 2 shows that a thermometer sensor is not connected
or that the measured temperature is higher than 850°C.
Err 3 shows that the data coming from the thermometers sensor
is corrupted.
