Beijing Huahuan Electronics Co., Ltd
Huahuan
- 20 - TDMUX-16 User Manual V1.2
Table 5.3-2 VLAN management parameters
Parameters
Options
Explanation
VLAN
Managemen
t
VLAN Mode
（
E1/T1
）
802.1Q
802.1Q add VLAN tag on Ethernet frame.
QinQ add operators VLAN (S-Tag) in 802.1Q.
Realizing VLAN stack.
Suit for the network with VLAN Priority, ensuring
E1/T1 QoS.
Q in Q
VLAN Mode
（
Ethernet
）
Disable
Disable VLAN setting, there is no VLAN tag, suitable
for network without VLAN priority;
Enable 802.1Q VLAN or Q in Q, it will add VLAN tag
or double VLAN tags in the front of Ethernet frame.
Suitable for network with VLAN priority.
802.1Q
Q in Q
Ethernet Port
VLAN
Configuration
Eth No.
Ethernet port number 1~7
1
～
6 is Data/Uplink port, 7 is internal trunck.
VID
VLAN ID, support 4096 VLAN, ID, range (0-4095)
Priority
Define customer priority, including 8 PRI degree(0-7),
PRI is higher when this number is bigger.
E1/T1Port
VLAN
Configuration
No.
E1/T1port number 1
～
16
Enable
After ticking off, customer could set E1/T1 VLAN VID
and PRI; otherwise, E1/T1 VLAN VID and PRI will
set as default port7.
VID
VLAN ID, support 4096 VLAN, ID, range (0-4095)
Priority
Define customer priority, including 8 PRI degree(0-7),
PRI is higher when this number is bigger.
VLAN Table
VLAN table configuration, inquiry, add and delete.
Select: when add VLAN group or VLAN members,
property configuration changed, this should be
tick off.
VID: VLAN group ID, support 0-4095
Mbr.: VLAN group member, it will be VLAN member
when tick off
Untag: tagged/untagged, ticking off means (untag)
Next
Ethernet VLAN way, Ethernet port VLAN and VLAN
table configuration confirm.
5.3.2 Service configuration indication
1. Bandwidth auto adaptation for E1/T1 depends on the connection of E1/T1 is enabled or
disabled. It is suggested to disable this channel of E1/T1 when it is not used.
2. The MAC address of H0FL-ETHMUX V16 is fixed in the device. It is an only, fixed,
and 12-hex MAC address, such as 80-80-80-80-80-80, then it could communicate with other
equipments. H0FL-ETHMUX V16’s MAC address is already fixed, no need to set again. ARP is
supported and the remote end MAC address can be got through auto-negotiation. So it is
unnecessary to set the MAC address for the remote end, but IP address is needed.
