BT Downloader
User Guide
How to login
To configure your BT Downloader , you will need to use the web browser, enter the IP
address and then use the web configuration for further setup. To find out the ip address
of your device once it is connected to the network,there are several different ways as
described on the following pages.
Login on a PC
Use the NetTool utility included on the CD. This will list the device automatically and allow
you to access the web configuration interface with a simple click of your mouse. You may
also use the same utility at a later point to map the network drive after you setup your
shares.
1. Turn on your BT Downloader and make sure it is connected to the same network as
your computer.
2. Start the NetTool utility by double clicking on the EXE file.
3. Your BT Downloader will automatically show up in the device list but if not,make sure
the NetTool has access to the network.You might have to configure your firewall or
even temporarily turn it off.
4. Click on your device and it will list all the details.
2
1
5. Previously greyed out commands will now be available and you can click on
“Access via web”.
Note: Alternatively, you could use the Setup Wizard to configure the basic settings and
view the IP address. Open your web browser and then manually input the IP address to
access the web configuration interface.
Page 5 / Chapter 2 - System Setup
