BT Downloader
User Guide
Login on a Mac
First, you will have to find out the IP address of your BT Downloader and then
use the web browser to access the web configuration interface.
1. Turn on your BT Downloader and make sure it is connected to the same network
as your computer.
2. Start the Terminal utility, which is usually located in your Applications folder under
Utilities.
3. Type nmblookup NSD***, where the star marks represent the last 6 digits of your
Mac address. This number can be found on a sticker either on the outside of your
device or on the bridge board itself.
The command would therefore look something like this:
nmblookup NSDDDEE03
4. After entering the previous command and hitting the Enter key, it should return an
IP address, followed by the name you just entered.
5. Open your web browser and enter the IP address from the previous step to access
the web configuration interface.
Peer to Peer
If you connect the BT Downloader directly to your computer via Ethernet cable,you can
access it using its default IP 192.168.16.1. Open the web browser and enter 192.186.16.1
to access the web configuration interface.
Page 6 / Chapter 2 - System Setup
