4-1 Choose Proper Bolts
4-2 Install Monitors to the Arms
08
Be sure to keep the arm in
horizontal position during
adjustment. Or else, it would
be difficult to adjust the
mount or damage the mount.
1. If the monitor can stay at the desired height
by itself, no adjustment needed.
2. If the monitor rises up, press the arm to
keep it in horizontal position and then use the
13/64 in. (5mm) Allen key (G) to turn the bolts
clockwise(“-” direction) to reduce tension of
the arm only until the monitor can stay at the
desired height by itself.
3. If the monitor falls down, lift the arm to
keep it in horizontal position and then use the
13/64 in. (5mm) Allen key (G) to turn the bolts
counter-clockwise(“+” direction) to increase
tension of the arm only until the monitor can
stay at the desired height by itself.
0.1-0.2in.(3-5mm) spacing left
between the end of bolt and monitor
back
Phillips
Screwdriver
[Not Included]
Flat back monitor
Curved back monitor
The tension is preset at
8.8-11 LBS(4-5kg).
After hanging the
monitor to the mount,
please release the
monitor slowly to
prevent it from falling
suddenly.
100x100mm
75x75mm
A
100x100mm
75x75mm
B-1
B-2
Step 2 Attach Monitors to the Arms
Step 3 Adjust Gas Spring Tension
75 mm ≈ 3 in.
100 mm ≈ 4 in.
