WenZhou ZhengBang Electronic Equipment Co., Ltd
ZB4050LS Rev 1.1
14
Chapter 4 System Edit
Process
PCB
File
Mark
Feeder
Export
Preparation
：
Turn on the machine and connect to the air source, take another PCB to be produced, adjust the width of the rail (depends on PCB size),
and then place the PCB at the front end (left side) of the rail, and click “Load” to transport the PCB to the mounting area and clamped.
4-1 How to edit PCB
4-1-1 How to edit origin
Fig.4-1 Origin Edit
Select” Edit—PCB” to enter the PCB management interface.
Double-click X/Y content to edit coordinate, locate camera center to the PCB origin position, and click “Confirm” to save it.
！
Attention
：
Origin subject to the setting when the PC component is exported.
Origin usually be set in the bottom left corner. Consider cut of the edge accuracy of PCB is not as required, it
is recommended to select the lower left corner insert via, and the MARK or lower left corner component pad
is more suitable for the origin.
4-1-2Mutiple Board
Enter the PCB, click “Add” or “Reduce” to add the number of boards.
Select the multi-board, double-click X/Y to move the camera cross to the origin, and click “Confirm” to save it.
Board needs to be done, just “√” under “ON” column.
4-1-3 Multi-Board Form
For the arrangement of multiple board for quick edit.
1.After origin is completed, click “Arrange” to edit the parameter.
2.Edit the number of board in X and Y axis
3. Click "Get Spacing and Angle" and then move the coordinate alignment in order according to the prompt
4.the origin of left lower corner of the multi-board
；
