AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
5 Appendix
Issue 01 (2017-12-29)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
61
Step 7
Cut off the surplus cables along the lower edge of the wire holder, as shown in Figure 5-45.
Figure 5-45
Cutting off surplus cables
Step 8
Put the connector body onto the wire holder and turn the metal shell by 90°, as shown in
Figure 5-46.
Ensure that the wire holder is in good contact with the connector body.
Figure 5-46
Putting the connector body onto the wire holder
Step 9
Push the metal shell toward the connector body until the wire holder and the connector body
are engaged completely. Crimp the connector, as shown in Figure 5-47.
