5
8
Installing an Antenna Fastener and Lightning Rod
Site
Latitude
Lightning Rod
Tilt Angle
0
–15
°
15
°
16
–25
°
25
°
26
–30
°
35
°
31
–45
°
45
°
Adjust the tilt angle of the lightning
rod based on the site latitude.
10
Installing the Power Module and Lithium Battery
Wear gloves during installation.
Do not place a module with its bottom against the ground.
Never install a module with power on. Ensure that the angle between a module and the line vertical to the ground is within 10 degrees.
The paint on the module exterior should be intact. If paint has flaked off, repaint the area to avoid corrosion.
Installing the Power Module and Lithium Battery on a Pole
10.1
9
Installing an Antenna
For the antenna installation method, see the antenna document.
1. Use a positioning
sticker to mark the
installation position
for the pole
mounting kit.
Pole Diameter
(105
–140 mm)
Ensure that the arrow on the top of the pole mounting kit points exactly to the middle point on the top of the
positioning sticker.
There are three types of bolts available for installing the pole mounting kit. Choose the appropriate type of
bolts based on the pole diameter.
Bolt
(190 mm)
2. Install the pole mounting kit.
Positioning
sticker
Bolt (120 mm)
Bolt (160 mm)
Cable hole
Pole Diameter
(140
–175 mm)
Pole Diameter
(175
–210 mm)
NOTE
NOTICE
