Settings: Device Management
Auto delete recordings
By default, your YouView box is set to delete old
recordings automatically when the hard disk
runs out of space. However, to prevent this, use
the arrow keys to select ON or OFF.
Software update
YouView will automatically update your
software overnight, if the box is left in standby.
You can use this setting to check for updates
manually.
Update on demand players
Checking for updates to On Demand players
is performed automatically. However, you can
check for updates yourself by selecting Check
Now.
Reset your YouView box
Use this option if you want to reset your
YouView Box and restore it to its factory
settings. However, this will also reset your
PIN, any preferences you have set, delete
your postcode and all your current and future
recordings and reminders.
Note: Resetting your YouView box will delete all
your recordings. Make sure you have watched
all the programmes you want to see before you
reset your box.
Automatic standby time
This option controls when or if your YouView
box should go into standby mode. By default,
it will go into standby after 3 hours if you have
not interacted with it.
To change the default setting, press
OK
on
Automatic Standby Time and use the arrow
keys to select 2, 3, 4 or 12 hours.
Eco mode
Use this option to manage the energy settings
for your YouView box. By default this is set
to HIGH, the most energy efficient mode. By
changing this setting to LOW your YouView box
will only go into active standby, which is less
energy efficient but will reduce the start up
time.
RF loop through
If you wish to supply the aerial signal to
another device e.g. TV’s use this option to
enable the Antenna Out connection on your
YouView box. By default, this is set to OFF.
20
Summary of Contents for DN371T
