NOTE
l
If the WAN interface obtains IP addresses in static or DHCP mode, choose
WANIPConnection
to set the parameters of the WAN interface.
l
If the WAN interface obtains IP addresses in PPPoE mode, choose
WANPPPConnection
to
set the parameters of the WAN interface.
l
Configure the parameters of the WAN interface – Bridge
1.
Choose
InternetGatewayDevice
>
WANDevice
>
1
>
WANConnectionDevice
from the navigation tree. Click
Add
in the lower left part to create an instance.
2.
Choose
2
>
WANPPPConnection
from the navigation tree. Click
Add
in the lower
left part. Choose the new
1
branch from the navigation tree. In the right pane, set the
parameters as follows:
–
Set
Enable
to
1
, indicating that the WAN connection is enabled.
–
Set
Connection Type
to
IP_Bridged
, indicating that the connection type of the
WAN interface is in bridge mode.
–
Set
X_HW_SERVICELIST
to
INTERNET
, indicating that the service type of
the WAN interface is Internet.
–
Set
X_HW_VLAN
to
40
, indicating that the VLAN ID of the WAN interface is
40.
–
Set
X_HW_PRI
to
1
, indicating that the priority level of the WAN interface is 1.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
3 Configuration
Issue 04 (2011-01-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-229