EDGE U0-6 Simplified Maintenance Manual
12 Replacing the P6's PCBA Without Removing the Battery
Issue 1.0 (2013-01-12)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
84
12
Replacing the P6's PCBA Without
Removing the Battery
12.1
Disassembly Procedure
Follow steps 1 to 17 in Chapter 7 to disassemble the phone. Then remove the two screws indicated by the
boxes in Figure 1.
1.Pry the GPS antenna rack and bend it for 90 degrees along the turning line shown in Figure
4.
a. Use tweezers to gently pry the fifth clip on the left of the GPS antenna rack. Apply force in the Z direction.
b. Use tweezers to gently pry the fourth clip on the right of the GPS antenna rack. Apply force gently downward
and then pry the clip upward.
Figure 1
Figure 2
c. Use tweezers to gently pry the third clip on the left of the GPS antenna rack. Apply force from the inside of the
front cover.
d. Bend the GPS antenna rack along the turning line (indicated by the red line in Figure 4) for 90 degrees.
Note: The GPS antenna rack can be bent only twice. If bent for the third time, the GPS antenna rack must be
scrapped together with the battery.
The fifth clip
The fourth clip