eSpace IAD208E(M) Integrated Access Device
Quick Start
4
Manual Configuration (Web)
Issue 04 (2012-06-11)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23
2.
Set the parameters in the
WAN
area. As planned, set the IP address for the
IAD208E(M) to
192.169.1.62
, subnet mask to
255.255.255.0
, and default gateway
to
192.169.1.1
. Click
OK
.
There are three methods for obtaining the IP address. Select a method according to the actual
network and configure with the help information on the Web.
3.
A confirm dialog box is displayed, as shown in the following figure. Click
OK
.
The IAD restarts automatically. Log in to the system again after about two minutes.
If change IP obtain mode, the new IP address may be changed after the IAD restarts
automatically. With dialing *127 to listen to the IP address through the telephone
connected to the IAD or connecting to the IAD through the serial port cable to view the
IP address.
When DHCP or PPPoE is selected, it takes you about 8 minutes to restart the IAD if the
IAD cannot obtain IP address from the DHCP or PPPoE server. And please check the
network ensure the DHCP or PPPoE server available and the information of the server
is right.
After changed the IP address, log in the system again, and proceed from
Step 2
.
4.
Set the DNS IP address.
If the DNS server exist in the actual networking, set the parameters in the
DNS
area
on the IP address setting page of IAD web management to implement connecting to
other network devices according to the domain name.
a.
Set
DNS obtain mode
to
Manually
or
Automatically
. If
Static
is selected to
obtain the IP address, you can select only
Manually
.
b.
Enter an IP address in Primary DNS IP and enter an IP address in Secondary
DNS IP as required.
c.
(Optional) Set Domain name suffix, for example, set it to huawei.com.
Step 4
Configure the SIP server.
1.
Click
Next
, and the page of
SIP Service Configuration
>
SIP Server
is displayed.
