FusionModule1000B Air-Cooled IT Solution
Maintenance Guide
6 Parts Replacement
Issue 02 (2017-01-10)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
109
Figure 6-28
Removing screws that secure the camera to its base
Step 3
Remove the network cable and take out the camera.
Step 4
Install the new camera by following instructions in documents delivered with the camera,
tighten the screws to secure the camera to its the base, and reconnect the network cable in the
original way.
Step 5
Adjust the angle of the camera to cover the monitored area by following instructions in
documents delivered with the camera, and reinstall the transparent cover.
Step 6
Configure the camera by referring to the management system initial configuration table in the
initial configuration parameter manual for the solution in use.
The original parameter settings can be used.
Step 7
Check that the new camera is working properly.
----End
Follow-up Procedure
Dispose of the removed camera that is confirmed faulty.
6.3.9 Replacing a VCN500
Prerequisites
A VCN500 needs to be replaced.
A spare VCN500 of the same model is available and functional.