FusionModule1000A40 ICT Solution
Maintenance Guide
3 Routine Maintenance
Issue 01 (2019-03-05)
Copyright © Huawei Technologies Co., Ltd.
28
Check
Item
Operation
Check Standard
Troubleshooting
RF_Z
indicator
On: No network
parameters exist. A
network is waiting
to be created.
Blinking slowly: A
network is set up,
and node access is
not allowed (the
indicator blinks at
0.5 Hz, on for 1s
and then off for 1s).
Blinking at super
short intervals: A
network is set up,
and node access is
allowed (the
indicator blinks at
10 Hz, on for 0.05s
and then off for
0.05s).
Blinking at super
short intervals
intermittently: The
device is searching
for a network (the
indicator blinks at 2
Hz, on for 0.5 and
then off for 0.5s).
Refer to
ECC800 Data Center
Controller V100R001C30 User
Manual
to register the device, or
contact Huawei technical support.
AC
actuator
Power input
Input voltage:
90–240 V AC
Check the input power cables if the
input voltage is abnormal.
Power output
Output voltage:
90–240 V AC
For details, contact Huawei technical
support.
PWR
indicator
Steady on: The
power supply is
normal.
Off: No power
supply is available.
Check the input power cables.
ALM
indicator
Steady on: A fault
alarm is generated.
Off: No fault alarm
is generated.
Refer to
ECC800 Data Center
Controller V100R001C30 User
Manual
to handle alarms, or contact
Huawei technical support.