iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
143
Figure 6-17
Configuring Camera NTP Synchronization
4.
In the search results, click
Edit
in the row where
Parameter Name
is
NTPIPC
and set
Value
to
1
.
5.
Click
Save
. After the camera NTP synchronization function is enabled, the camera, after
being connected to the server, will automatically time-synchronize with the server.
----End
Follow-up Procedure
The VCN500 automatically restarts after the IP address is modified. The restart takes
about 5 minutes. After the restart, use the new IP address to access the VCN500.
Change the PC IP address to an address in the network segment of the new VCN500 IP
address, enter the VCN500 IP address in the address box of the Internet browser, and log
in to the OMU Portal system.
(Optional) Deploying IVS in Stack Mode. For details, for details, refer to
(Optional)
Deploying IVS in Stack Mode
in
VCN500 Product Documentation
. Log in to
http://e.huawei.com/
to obtain the document.
(Optional) Deploying MPUs in Cluster Mode. for details, refer to
(Optional) Deploying
MPUs in Cluster Mode
in
VCN500 Product Documentation
. Log in to
http://e.huawei.com/
to obtain the document.
6.3.2.1.2 Changing the Preset Password for the VCN500 Servers
Context
To ensure password safety, you need to change the OMU Portal login password periodically.
Procedure
Step 1
Log in to the OMU portal of the MPU server as the
Admin
user.
Step 2
Click
Change Password
at the upper right corner, as shown in
Figure 6-18
Changing a password
Step 3
Enter
Old Password
,
New Password
, and
Confirm Password
and click
Save
.
