iManager NetEco 6000
Device Installation and Commissioning Guide
6 Adding Devices
Issue 03 (2019-03-10)
Copyright © Huawei Technologies Co., Ltd.
241
Figure 6-83
Configuring RPDU MODBUS-RTU parameters
Table 6-44
MODBUS-RTU device parameter description
Parameter
Description
Name
Device name
IP Address
Set this parameter to the IP address of the collector to which the
device is connected.
Port
Set this parameter to the port through which the device connects to
the collector.
To learn ports on the ECC collector, see Setting RS485 Parameters
for the ECC500 V6 Collector.
Device Address
Set this parameter to the address set on the device.
Timeout period
Timeout duration for connection test (set to
3s
by default)
Step 7
Click
Connection Test
to start the connection test.
