Affixing a Label to a Signal Cable
The label affixing position on a signal cable is 2 cm away from the connector. In special cases,
for example, to avoid bending the cable or affecting other cables, affix the label to a different
position on the cable.
A label should be affixed to each end of a cable. When the cable is placed vertically, the label
should point towards the right. When the cable is placed horizontally, the label should point
downwards.
shows how to affix a label to the signal cable in a proper position.
Figure 15-5
Affixing a label to a signal cable in a proper position
1
06
A 01 2
A
TO:
1
06
A
01
2
A
TO:
shows how to affix a label to a signal cable.
Figure 15-6
Affixing a label to a signal cable
Affixing side
2~3 mm
1
06
A 01 2
A
TO:
Affixing a Label to a Power Cable
Remove a label from the bottom of the label page, and then affix it to the concave part on either
side of the identification plate of a cable tie. Ensure that the label directions are consistent in the
equipment room. The cable tie should be fastened 2 cm away from the connectors. In special
cases, the labels can be affixed to other positions.
Cable ties should be fastened at both ends of a cable. After bundling the cables, the completed
identification plate should be visible on the top of the cable in the horizontal cabling, or on the
right side of the cable in the vertical cabling. Make sure that the label points outwards, as shown
in
.
OceanStor N8500 Clustered NAS Storage System
Installation Guide (for T Series V100R005)
15 Cable Labels
Issue 02 (2015-09-22)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
328
