5.18 Front Drive Backplane
5.19 Rear Drive Module
5.20 Left Mounting Ear Plate
5.21 Right Mounting Ear Plate
5.22 Mainboard
5.1 Tool Preparations
Prepare the following tools:
●
ESD wrist strap or ESD gloves
●
M3 Phillips screwdriver
●
Protective gloves
●
ESD bag
●
Flat-head screwdriver
5.2 ESD Protection
5.2.1 Operation Instructions
To minimize ESD damage, observe the following precautions:
●
Lay ESD floors or ESD cushions in the entire equipment room, and use ESD
chairs. The equipment room is equipped with ESD clapboards, ESD screens,
and ESD curtains.
●
All floor-standing electric devices, metal frames, and metal chassis shells in
the equipment room must be directly grounded. All electric meters or tools on
a workbench must be connected to the common ground point of the
workbench.
●
Monitor the temperature and humidity in the equipment room. The heating
system reduces indoor humidity and increases ESD.
●
Place components in ESD bags or boxes during transportation or storage.
●
Wear an ESD wrist strap when installing or removing a server component.
Ensure that the ground terminal of the ESD wrist strap is inserted into the
ESD jack in the chassis.
●
Before touching a device, ensure that you are wearing ESD clothing and ESD
gloves (or wrist strap), and remove any conductive objects (such as watches
and jewelry).
shows conductive objects that must be removed
before you touch a device.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280)
5 Removal and Installation
Issue 04 (2020-01-16)
Copyright © Huawei Technologies Co., Ltd.
72
