TP48200A-HX09A2 & TBC300A-TCA2
Installation Guide
10 Commissioning
Issue 01 (2013-10-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
82
10.2 Setting the Display Language
After powering on the SMU, select English by pressing
or
on the LCD, and then
press
to enter the standby screen.
If you select an undesired language, remove and then insert the SMU. Select a language again after the
SMU restarts.
10.3 Setting the Date and Time
The LCD screen becomes dark if no button is pressed within 30 seconds.
You need to log in again if no button is pressed within 1 minute.
The preset password is
000001
.
Set the date and time as required.
Table 10-1
Setting the date and time
Main Menu
Second-Level
Menu
Third-Level
Menu
Default Value Setting Value
Setting Wizard
Date and Time
NOTE
The date and
time vary
according to
time zones. Set
the time zone,
date, and time
based on the
local situation.
Date and Time
-
Set to the local
date and time.
Time Zone
UTC +08:00
Beijing
Set to the local
time zone.
NTP Enable
No
Yes/No
NOTE
Set the
parameter to
Yes
if you need
to synchronize
the SMU time
and the site
network server
time.
10.4 Setting Battery Parameters
Set Battery1 connected, Battery2 connected, Battery3 connected, Battery4 connected, battery
rated capacity, BLVD enable, battery installation time and volt. test mode as required.
