Huawei U-SYS IAD101H, Quick Start Manual

4

 Configuration (Command Line Mode) 

U-SYS IAD101H/102H/104H Integrated Access Device 

Quick Start 

14 

Huawei Proprietary and Confidential        

Copyright © Huawei Technologies Co., Ltd. 

Issue 02 (2011-02-09) 

2.

Select 

Obtain an IP address automatically

 on the PC that is connected to the 

LAN port of the IAD. The IAD then allocates a LAN IP address to the PC, such as 
192.168.100.10. 

To access network by the preceding method, ensure that the IAD is in the NAT (Network 
Address Translation) mode. Run 

display nat

 in the global configuration mode to check that 

whether the IAD is in the NAT mode. If the CLI does not display that 

NAT is started

, 

run 

nat enable

 to enter the NAT mode. 

4.6 Setting the UCEMS Parameters 

On the IAD, you can set the basic parameters for the communication with the Unified 
Communication Element Management System (UCEMS) so that the IAD can accept 
the management from the UCEMS. 
Before setting the UCEMS parameters, run the display physical-serial-num command 
to view the physical serial number. If the configuration is inconsistent with that on the 
UCEMS (To obtain the physical serial number set on the UCEMS, contact the network 
administrator), run the physical-serial-num command in the global configuration mode 
of the IAD to synchronize the physical serial number. 
Generally, only the IP address of the UCEMS needs to be configured. For example, run 
the nms primary command to set the IP address of the UCEMS to 

192.168.1.201

. The 

operation is as follows: 

TERMINAL(config)#

nms primary 192.168.1.201

Run 

display nms

 to view status of the IAD registering to the UCEMS. 

TERMINAL#

display nms

  the  config  is  IP  

------------------------------------------------------------------

------