CFcard
8. List file in
CFcard
9. Delete file from
CFcard
10. Set patch
mode
11. Set version back
signal
12.
Reboot
Press Ctrl+B to return Main Menu in any sub
menu.
Enter your choice(1-12):
3
2.
In the Ethernet submenu, enter
3
to modify Ethernet interface boot parameters. As shown
in the output, the parameters that must be set are commented. For the other parameters,
keep the default values. After the settings are complete, return to the Ethernet submenu.
Ethernet
Submenu
1. Download file to SDRAM through ethernet interface and
boot
2. Download file to CFcard through ethernet
interface
3. Modify ethernet interface boot
parameters
4. Return to main
menu
Enter your choice(1-4):
3
Note: two protocols for download, tftp &
ftp.
You can modify the flags following the
menu.
tftp--0x80,
ftp--0x0.
'.' = clear field; '-' = go to previous field; ^D =
quit
boot device :
mottsec3
processor number :
0
host name :
host
file name : vxWorks.st
V500R001_software.cc
//Indicates the
name of the file to be downloaded.
inet on ethernet (e) : 192.168.71.0
172.16.104.208
//Indicates the IP
address of the local interface. This IP address must reside on the same
subnet as the FTP server IP address.
inet on backplane
(b):
host inet (h) : 192.168.61.0
172.16.104.10
//Indicates the IP
address of the FTP server
gateway inet (g) : //Indicates the gateway IP
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
341
