Figure 3-9
Removing an FPIC from the LPU
4.
Place the removed FPIC into the ESD bag.
Step 6
Insert a new FPIC into the LPU.
1.
Take out the new FPIC from the ESD bag.
NOTICE
– Pull out the LPU slowly and smoothly to prevent it from hitting neighboring boards
and affecting running boards.
– Touching parts on the LPU when swapping it may damage the LPU.
2.
Hold the captive screws of the FPIC, and insert the FPIC smoothly along the guide rails
of the slot until the FPIC is completely seated in the slot, as shown in
3.
Using the Phillips screwdriver, turn the two captive screws clockwise to tighten them, as
shown in
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
354
