l
Run the
display device pic-status
command on the console interface to view the running
status of SPCs. If the SPCs on the corresponding SPUs are working normally, the
following is displayed:
<sysname>
display device pic-status
Pic-status information in Chassis
1:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-
SLOT PIC Status Type Port_count Init_result Logic
down
Registered
Cpu
1 1 Registered SPU_CARD_TYPE_SPCC 0 SUCCESS
SUCCESS
CPU3
2 1 Registered ETH_12XGE_CARD 12 SUCCESS
SUCCESS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-
Step 7
Check whether services are working normally.
----End
Follow-up Procedure
After replacing the SPC, collect all tools. If the replaced SPC is faulty, fill in the
and send the faulty module with the Repair Transmission Sheet to the
equipment supplier or the specified repair service provider.
3.2 Expanding SPU Capacity
This section describes how to expand SPU capacity.
3.2.1 Expanding SPU Capacity for the Active and Standby FWs in
Hot Standby Scenarios (V500R001C50 and Later Versions)
This section describes how to expand SPU capacity for the active and standby FWs in hot
standby scenarios.
Precautions
Expand SPU capacity as follows only when V500R001C50 or a later version is being used on
the FW.
Before expanding SPU capacity, prepare new SPUs. The SPUs to be installed on the active
and standby FWs for capacity expansion must be of the same model. In addition, they must be
installed in the same slot on the active and standby FWs.
If two FWs work in active/standby mode, you must first expand the SPU capacity for the
standby FW and then for the active FW. If two FWs work in load balancing mode, run the
hrp switch active
command on one FW to switch the operating mode to the active/standby
mode and then expand SPU capacities.
The following table lists which services are affected when an SPU is hot-swapped.
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
363
