Figure 3-15
Inserting an SPU
Step 6
Check the running status of the inserted SPU.
1.
Run the
display device
command on the standby FW to query the running status of the
SPU motherboard. The SPU motherboard is running properly if all items on the SPU
motherboard in the corresponding slot are displayed as follows:
HRP_S<sysname>
display device
USG9520's Device status:
Slot # Type Online Register Status Primary
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 SPU Present Registered Normal NA
2 SPU Present Registered Normal NA
3 LPU Present Registered Normal NA
4 MPU Present NA Normal Master
6 CLK Present Registered Normal Master
8 PWR Present Registered Normal NA
9 PWR Present Registered Abnormal NA
10 FAN Present Registered Normal NA
2.
Run the
display device pic-status
command on the standby FW to query the running
status of the subcard. The subcard is running properly if all items on the corresponding
subcard are displayed as follows:
HRP_S<sysname>
display device pic-status
Pic-status information in Chassis
1:
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-
SLOT PIC Status Type Port_count Init_result Logic
down Registered Cpu
1 0 Registered SPU_CARD_TYPE_IPS 0 SUCCESS
SUCCESS CPU1
1 1 Registered SPU_CARD_TYPE_SPCC 0 SUCCESS
SUCCESS CPU3
2 1 Registered SPU_CARD_TYPE_SPCH 0 SUCCESS
SUCCESS CPU2,CPU3
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
367
