Figure 3-42
Inserting CF card 1
Step 10
Check whether the new CF card is working normally.
You can check the running status of the new CF card in the following ways:
l
Check the CF ACT indicator (green) on the panel of the MPU/SRU. If it is steady on or
blinking, the new CF card is working normally.
l
Run the
dir
command on the console interface to check whether the new CF card can be
displayed. If the new CF card is working normally, the following is displayed:
<sysname>
dir ?
/all List all files
STRING<1-64> [drive][path][file name]
cfcard2: Device name
cfcard: Device name
slave#cfcard2: Device name
slave#cfcard: Device name
The preceding output also indicates that the new CF card has returned to the normal state. If
the new CF card does not work normally, contact a local Huawei office for technical support.
----End
Follow-up Procedure
After replacing the CF card, collect all tools. If the replaced CF card is faulty, fill in the
and send the faulty module with the Repair Transmission Sheet
to the equipment supplier or the specified repair service provider.
3.5.2 Replacing CF Card 2
This section describes the procedure for replacing CF card 2.
Context
Before replacing CF card 2, note the following:
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
397
