Figure 3-2
Removing CF card 1
1
2
2.
Put CF card 1 removed from the new MPU into the electrostatic discharge (ESD) bag.
3.
Insert CF card 1 removed from the to-be-replaced MPU to the CF card 1 slot of the new
MPU and press the CF card as shown in (1) in
.
Figure 3-3
Inserting CF card 1
1
Step 12
Insert the new MPU/SRU into the chassis.
1.
Support the lower edge of the new MPU/SRU with one hand and hold the panel with the
other hand. Then, insert the new MPU/SRU smoothly into the chassis along the guide
rail of the slot. Stop sliding the MPU/SRU forward when the ejector levers on the front
panel of the MPU/SRU reach the chassis, as shown in
(1).
2.
Turn the ejector levers on the MPU/SRU outward and upward to form a 45-degree angle,
and at the same time push the MPU/SRU into the slot. Then, turn the ejector levers
HUAWEI USG9500 Series
Hardware Guide
3 Hardware Maintenance
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
339
