Figure A-48
Removing the jacket of a twisted-pair cable (unit: mm)
Step 3
Fit the metal shell onto the twisted-pair cable. The shield layer is covered by the metal shell,
as shown in
Figure A-49
Fitting the metal shell onto the twisted-pair cable
Step 4
Fit the metal shell onto the twisted-pair cable until the shield layer is covered completely.
Along the edge of the metal shell, cut off the shield layer with aluminum foil and ensure that
there is no extra copper wire protruding. Ensure that the exposed twisted-pair cable is about
20 mm long, as shown in
Figure A-50
Removing the shield layer of a twisted-pair cable (unit: mm)
Step 5
According to colors, lead the four pairs of twisted-pair cables through the wire holder, as
shown in
HUAWEI USG9500 Series
Hardware Guide
A Appendix
Issue 03 (2017-12-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
455
