Figure 4-141 Position 3 for installing a smart ETH gateway
(1) Smart ETH gateway
The methods for installing a smart ETH gateway on the three positions are similar.
This section describes how to install a smart ETH gateway on the M-shaped cable
trough.
Procedure
Step 1 Secure the guide rails for a smart ETH gateway to the M-shaped cable trough on
the top of the cabinet using two M4 screw assemblies, as shown in
.
Step 2 Install the smart ETH gateway to the guide rail, as shown in
.
Figure 4-142 Installing a smart ETH gateway
1. Align the upper slot of the guide rail for the smart ETH gateway with the
upper part of the guide rail, and pre-mount it onto the guide rail.
2. Press the lower part of the smart ETH gateway to clamp the smart ETH
gateway onto the guide rail.
3. Shake the smart ETH gateway in different directions to ensure that it is
reliably installed.
Step 3 Connect the smart ETH gateway ground cable to the ground point on the M-
shaped cable trough, as shown in
.
Step 4 Attach the ETH converter to the smart ETH gateway.
----End
FusionModule800 Smart Small Data Center
User Manual
4 Installation Guide
Issue 01 (2021-02-05)
Copyright © Huawei Technologies Co., Ltd.
193