1. Remove screws from the emergency door release button using a Phillips
screwdriver, as shown by (1) in
2. Remove the glass panel of the emergency door release button, as shown by
(2) and (3) in
3. Remove screws from the base, and remove the base, as shown by (4) in
.
Step 2 Mark the mounting holes using a marker and the base.
Figure 4-176 Marking mounting holes (unit: mm)
Step 3 Drill holes using a hammer drill, and route cables out of the cable hole.
Step 4 Install the emergency door release button.
Figure 4-177 Installing an emergency door release button
1. Install the base of the emergency door release button, as shown by (1) in
.
2. Install the glass panel of the emergency door release button, as shown by (2)
.
3. Tighten screws of the emergency door release button using a Phillips
screwdriver, as shown by (4) in
----End
4.2.9.19 (Optional) Installing an In-Room Camera
FusionModule800 Smart Small Data Center
User Manual
4 Installation Guide
Issue 01 (2021-02-05)
Copyright © Huawei Technologies Co., Ltd.
214